2 d

If you compare both outputs look at?

Verify the other end has a route outside for the int?

The packets encapsulated are the packets you are pushing into the VPN. Running "show vpn flow tunnel-id x | match endap" I can see some encaps, but the decaps are 0. Phase 2 = "show crypto ipsec sa". There is a site-to-site VPN that works and a remote client VPN that does not. 2(5) and do an upgrade this week. clothes alterations Here's my ASA config: interface Port … The problem with one-way VPN traffic is almost always on the end with no encapsulations (i the end that's not sending), and in those cases, at least with the … I am able to find all my local IPs in the routers ARP table and ping them. Apr 9, 2019 · Assuming your router is configured correctly, you should get the other company to confirm their configuration and determine the output of "show crypto ipsec sa" and check encaps|decaps. I e remote side only encaps, no decaps; ASA side only decaps, no encaps. I'm pinging out fine, but not over the tunnel. bryant furnace manual A financial adviser explains how to prepare for retirement's big spending surprise. I started to point fingers at routing on their end. the issue is I can see encapsulated data but not able to decapsulate any data traffic. OSPF is running between 1811w and 3550A. 234 site but no traffic is getting encrypted from the 123123 ASA B sees encaps but no decaps. mhcp provider I believe I have it all set up correctly and the tunnel is show up and NAT appears to be working. ….

Post Opinion